The introductory part discusses the application of modern technologies and their significance in modern production. In addition, the technology of laser cutting and the functioning of the laser were explained through various examples from production. The experimental part of position preparation, program preparation and laser cutting was done at the company Đuro Đaković Special Vehicles. Using the TRUMPF TRUMATIC L3050 CO2 laser, the positional pieces were cut from structural steel from sheet S3555J2+C. And according to the created program and input parameters, a techno-economic analysis was made for the creation of positions. The set parameters were made according to the rules of the profession with fixed and variable costs, and accordingly the cutting time and length of the cut were observed as the main factor for determining the price of the product. Analyzing the results, it was determined that for the creation of two positions by laser cutting, it is necessary to spend €91.80, of which the processing material with its price creates the most costs. The cutting cost for a processing time of 110 seconds is €1.3, and the material cost is €90 according to the current price from the supplier. According to this, the costs of working on the laser are fully justified by the price, and with any other processing, the product would cost more